Support
Write to support@ambiguouslabs.net. Please include the App ID shown on the watch under About › Support › Contact Us: that is how we find your watch, as we hold no name or e-mail for it.
Something went wrong during a dance? About › Support › Send Report sends us the watch's log. Quote the report number it shows.

The ANT+ icon
Top of the screen. The radio link to your partner's watch, about 10m.
![]() | Green: your partner's watch is connected. |
![]() | Orange, blinking: looking for your partner's watch. Come closer; it keeps trying. |
![]() | Orange: a short pause between two searches. The next search starts by itself. |
![]() | Red: the watch cannot search: no Partner ID yet, or no radio channel free. Set the Partner ID first. |
| No icon: Partner Dance is Off, or the Sharing Method is Internet Only. |

The globe
Bottom, left of the battery. Your own internet connection, through your phone. Shown while Partner Dance uses the internet or Group Dance is On.
![]() | Green: connected, and fresh data arrives from your partner or your group. |
![]() | Blue: connected, but nothing new from the others yet. Wait a moment, or check their watch. |
![]() | Red, blinking: trying to connect, no answer yet. It often settles within seconds. |
![]() | Red: nothing gets out. The phone is not connected to the watch, or Festival+ is not active (About › Support › Festival+). |

The GPS satellite
Bottom, right of the battery. Your own GPS. Shown while your location is shared: Share Location On in Partner Dance, or Group Dance On.
![]() | Green: good position. |
![]() | Yellow: weak position. Distance and direction are less precise. |
![]() | Red, blinking: searching for satellites. Go outside with a clear view of the sky; the first fix after a long break can take a few minutes. |
![]() | Red: the GPS could not start. Close Festival Together and open it again. |
On the compass screen the three icons sit together above the name, in the middle.
Questions we get
How do I pair with my partner?
Each watch must know the other's ID. Easiest: stand next to each other and open Sharing Settings › Partner Config › Pair Now on both watches. Each shows the other's ID; confirm it. Or type it in: your own ID is My ID under Partner Config, and your partner enters it as their Partner ID (and you enter theirs). Pairing works both ways: a watch that has not entered your ID back shows "partner not paired". My ID never changes, so you pair once.
ANT+, internet, or both?
Partner Config › Sharing Method chooses how Partner Dance reaches your partner:
- ANT+ and Internet (the default): the radio when you are close, the internet when you are apart.
- Internet Only: through your phones, at any distance.
- ANT+ Only: no phone, no internet; within about 10m.
Your partner's heart rate and dance details (how long they have danced, their stage and its time, their dance number) travel both ways: over ANT+ when you are close, over the internet when you are apart. Your partner's location travels over the internet only, so with ANT+ Only you see no arrow.
I cannot see my partner's or a friend's arrow
Look at your globe first.
- Red globe: nothing reaches you. Your phone is not nearby or has no coverage; fix that first.
- Green globe and "no location yet": their watch has no GPS position yet, or their sharing is Off. Share Location is Off until you switch it on, on both watches.
- "location not shared": your partner switched off Share Location under Partner Config.
- "out of range": they are farther away than the sharing distance (Location Range) they chose. Within it, the arrow appears.
- "last seen 3 min ago" and a dotted arrow: their watch stopped sending. Their phone is out of reach, or they closed the app. The arrow points to where they were last.
How far does location sharing reach?
Each watch sets its own distance under Sharing Settings › GPS Config › Location Range, from 10m up to 3km (1km unless you change it). Your range decides who may see you; theirs decides whether you see them.
How do we dance as a group?
Everyone enters the same Group Name and Group Key under Sharing Settings › Group Config, then switches Group Dance On. Anyone with the same name and key is in the group, so share them only with the people you dance with. To remove someone, change the key and tell the others.
The watch says "no phone" although the phone is next to it
The link between the watch and the phone is down, whatever the phone says. Open Garmin Connect on the phone; if that does not help, close Festival Together and open it again. "No internet" is different: the phone is connected but has no data. Check mobile data or Wi-Fi.
The GPS takes long to find a position
The GPS needs a clear view of the sky; indoors it may find nothing. The first position after a long break can take a few minutes, so switch your location sharing on before you reach the dance floor. If a position stays weak, try another setting under GPS Config › Satellites; the watch's own setting is the default.
How do stages work?
A stage is where you are dancing at the festival: the main stage, the techno tent, the beach bar, whatever you call it. A new watch starts with STAGE-1, STAGE-2 and so on; rename them under Dance Settings › Stage Settings (up to 7 letters each). When you move on, pick New Stage in the menu. While you dance, the screen shows the stage you are at under the time, or DANCING when none is chosen. Each stage keeps its own time, and it shows on your heart-rate graph and in the Dance History.
What do I see of my partner's dance?
Their dance time, their stage and its time, and their dance number, next to their heart rate. They arrive over ANT+ when you are within about 10m and over the internet when you are apart, so the screen keeps filling even if one of the two is out of reach.
How do I log water?
Log Water in the menu while you dance marks every drink and starts the hydrate reminder again.
The watch asks to calibrate the altimeter when the app starts
That page is the watch's own. It shows at the start of every activity that uses GPS (Garmin's Walk and Run do the same) when automatic calibration is off. To stop it, open the watch's settings, find Altimeter and switch automatic calibration On.
Is it really free? What is Festival+?
Yes. Festival+ is the name of the internet sharing. It switches itself on the first time the app starts, with no code and no account; About › Support › Festival+ shows its status. The relays cost money to run, so a coffee is welcome but not required.
I have a new watch
The new watch has a new My ID, so pair with your partner again.
Can I use it without a phone?
Yes. Everything on the dance floor works without a phone: your heart rate, zones and rest meter, the alerts, water and stages, the Dance History, and your partner's heart rate and dance details over ANT+.
Your partner's location, the internet backup for the dance details, and Group Dance travel through the Garmin Connect app on your phone, so for those the phone must be nearby and online.
Delete my data
On the watch: About › Support › Festival+ › Deactivate. The internet sharing stops at once (Partner Dance carries on over ANT+ only, Group Dance goes Off) and what the relay holds about you is deleted within a day. Details in the privacy policy.





